Enable-QasUnixGroup : Access is denied

Hello.

I am trying to run the command Enable-QasUnixGroup (part of the Quest.AuthenticationServices powershell module) and receiving the error "access is denied". The group I am running it against was created by the same account I'm using to run this command. I am unsure of what additional permissions may be needed or what other things I should check. My company apparently does not have any documentation on any internal setup relating to this, so I've just gone by the documentation, which is "Enable-QasUnixGroup -Identity 'group_name_here'"

Top Replies

JohnnyQuest 28 days ago +1

When you launch your Powershell window, make sure you do so using "Run As Administrator"

Also, if that doesn't work, try loading the module and executing the command in a **32-bit** Powershell…

0 JohnnyQuest 28 days ago

When you launch your Powershell window, make sure you do so using "Run As Administrator"

Also, if that doesn't work, try loading the module and executing the command in a **32-bit** Powershell window. Don't forget to use "Run As Administrator" once again.
Cancel
Up +1 Down

Reply

Verify Answer

Cancel
0 JohnnyQuest 28 days ago

Also note that the product is now known as Safeguard Authentication Services.

Here's a current article on the Powershell module.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel