• State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 15 subscribers
  • Views 6128 views
  • Users 0 members are here
Options
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

++ Disable auto load after tape was unloaded ++

JD168
over 6 years ago

Hello,

I'm using a LTO7 tape drive. After the last job the tape was unloaded. 


Command line I am using:

"C:\Program Files (x86)\Quest\NetVault Backup"\util\nvdeviceeject.exe -servername backup01 -devicename LTO7


Log/Job entry.
Sent device eject request...
Sent device eject request successfully!

 

So far so good. After a while the tape is loaded automatically again. I know there has to be a change in some config file, but I do not find where to change this.

Parents
  • 0 over 5 years ago
    The file "drives.tpl "I updated the last year can be found in "C:\Program Files (x86)\Quest\NetVault\ Backup\devices\drives".

    Line to change is:
    [Device:Poll Empty Drive]
    Tab Name = Configuration
    Label = Time between polling empty drive [0 = never] (mins)
    Type = Range
    Range = 0,1440
    Width = 5
    Value = 1 --> set this to "0"

    This can also be done via NetVault - Manage Devices - Tree View - Configure - Confiuration - set Time between polling empty drive to 0
Reply
  • 0 over 5 years ago
    The file "drives.tpl "I updated the last year can be found in "C:\Program Files (x86)\Quest\NetVault\ Backup\devices\drives".

    Line to change is:
    [Device:Poll Empty Drive]
    Tab Name = Configuration
    Label = Time between polling empty drive [0 = never] (mins)
    Type = Range
    Range = 0,1440
    Width = 5
    Value = 1 --> set this to "0"

    This can also be done via NetVault - Manage Devices - Tree View - Configure - Confiuration - set Time between polling empty drive to 0
Children
No Data