This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VA config

ESXi 5.5

vcenter 6 appliance

vRanger 7.3.1

Backups and restores only. No replication.

When creating a new VA within vRanger, under Virtual Appliance/Configuration, it shows VA name, IP, Host Name.

No matter where the VA gets migrated to, that Host Name information is never updated in Virtual Appliance/Configuration in vRanger.

Since we only do backup/restore, does it matter where VA is located, as long as it stays on the cluster? Or do we have to keep migrating it back to original host that vRanger thinks it is on?

Also, same question as above except for vRanger 7.1.1

Parents
  • Hello Scott,

    If the VA has been configured for cluster, it doesn't matter where the VA is located, it should be able to run the backups for all the VM's within that cluster. If you have set a VA per host, you should disable the DRS for all the Virtual Appliances.

    However, it should be able to update the host location within the VA configuration window. Have you tried refreshing the inventory within vRanger?
Reply
  • Hello Scott,

    If the VA has been configured for cluster, it doesn't matter where the VA is located, it should be able to run the backups for all the VM's within that cluster. If you have set a VA per host, you should disable the DRS for all the Virtual Appliances.

    However, it should be able to update the host location within the VA configuration window. Have you tried refreshing the inventory within vRanger?
Children
No Data