This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

++ Disable auto load after tape was unloaded ++

Hello,

I'm using a LTO7 tape drive. After the last job the tape was unloaded. 


Command line I am using:

"C:\Program Files (x86)\Quest\NetVault Backup"\util\nvdeviceeject.exe -servername backup01 -devicename LTO7


Log/Job entry.
Sent device eject request...
Sent device eject request successfully!

 

So far so good. After a while the tape is loaded automatically again. I know there has to be a change in some config file, but I do not find where to change this.

Parents Reply Children
No Data