This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Anybody updated to vRanger 7.6.3? Could you start Client then?

Hey Community,

today we tried to Update vRanger from 7.5.1 to 7.6.3. The update process was done without any failure.
After finishing we tried to start the client shell. We got only the message that the connection to the service is not possible.

But all services are started. Does anybody hast same problems?

After this we reverted the whole machine back to 7.5.1.

 

Greetings

Daniel from Germany

Parents
  • Hey Aaron, thank you for this idea. But sorry i didn't say, i tried this before recovering the whole machine.
    Unfortunately the was no vRanger +.evt in the given location "%SystemRoot%\System32\Config".
    And in the registry location “HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Eventlog" there is no single vranger key. There is a whole vranger folder with a few keys. Very confusing....
Reply
  • Hey Aaron, thank you for this idea. But sorry i didn't say, i tried this before recovering the whole machine.
    Unfortunately the was no vRanger +.evt in the given location "%SystemRoot%\System32\Config".
    And in the registry location “HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Eventlog" there is no single vranger key. There is a whole vranger folder with a few keys. Very confusing....
Children
No Data