This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DR-4000 NVRAM

Hi

my DR4000 fails because NVRAM have a damage, the part number of NVRAM its 4KP8H Dell Marvell PCI-E HA1CA22640FH-RA1V35. its very difficult found this part, but i found a similary part: Dell / Marvell Full Height 8GB Write Acceleration Card - H9DXY

Is compatible this part whit dr4000?

Parents
  • In the DR series there were two NVRAM cards.  There was the WAM1 used on DR4000 and DR4100, then later WAM2 used for DR4100,6000,4300,4300e, and 6300.

    On the DR4000 only the WAM1 could be used

    besides the 4KP8H part number you listed these other part numbers below that should work. (one looks very close to part number you lised H9DXY but D and X switched)

    5YG58
    1
    Module, Card, Controller, Marvell Semiconductor, DR4000
    H9XDY
    1
    Printed Wiring Assy, Controller, Non-Volatile Ram, Marvell Semiconductor, Adapter
Reply
  • In the DR series there were two NVRAM cards.  There was the WAM1 used on DR4000 and DR4100, then later WAM2 used for DR4100,6000,4300,4300e, and 6300.

    On the DR4000 only the WAM1 could be used

    besides the 4KP8H part number you listed these other part numbers below that should work. (one looks very close to part number you lised H9DXY but D and X switched)

    5YG58
    1
    Module, Card, Controller, Marvell Semiconductor, DR4000
    H9XDY
    1
    Printed Wiring Assy, Controller, Non-Volatile Ram, Marvell Semiconductor, Adapter
Children