Migration Manager for Active Directory

Forum RUM agents stopped after running for few hours

RUM agents stopped after running for few hours

ajithsmin over 4 years ago

RUM agents starts--> did discovery --> Comes OK --> It runs for 10 hours an approximately.--> It stopped with out processing.

Top Replies

Luke.Adams over 4 years ago +1 verified

Good Day,

If you are processing a server with the RUM UI, it's not surprising that things can take a long time and appear to do little. Review the corresponding log, this should help you understand…

+1 Luke.Adams over 4 years ago

Good Day,

If you are processing a server with the RUM UI, it's not surprising that things can take a long time and appear to do little. Review the corresponding log, this should help you understand what's happening.

If it doesn't help, open a Service Request with the support team for assistance, and we'd be happy to help.

Luke
Cancel
Up +1 Down

Reply

Reject Answer

Cancel
0 ajithsmin over 4 years ago in reply to Luke.Adams

Thanks ...we got a solution for this ....this was due to Reparse volume and suggested to perform the re-ACL using Vmover.exe ...Thanks of QUest PSO
Cancel
Up 0 Down

Reply

Verify Answer

Cancel