This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

++ nvdevice / nvcheckdrive ++

Dear NetVault Users,

I upgraded to version 11.1. Since then I cannot longer use my script for checking the tape I set for the first job running.

The following worked fine until the upgrade:

"C:\Program Files (x86)\Dell\NetVault Backup"\util\nvcheckdrive.exe -servername BACKUP01.GUDECO.DE -drivename LTO7

Now it is running into a:
"Target server is not a NetVault 7 server
Failed to get device tree from server 'BACKUP01.GUDECO.DE'."

Sure I can now use "nvdevice -check -drive LTO7". But this only works when the job running on the server where the LTO drive is connected to.
I don't want to change my order of jobs to get this running. Any Ideas?

Regards
Jens